Boveda Wooden Holder: Setup and Care Guide

By Cigar Chief | Published: 2026-10-23

Category: How-to Guides

Learn how to set up and maintain your Boveda Wooden Holder for optimal humidity control in your cigar humidor. Step-by-step instructions included.

Quick answer

Mount your Boveda Wooden Holder inside your humidor using the included magnetic plate, then insert two Boveda packs side by side for consistent humidity control.

Why use a wooden holder for your Boveda packs?

Boveda packs work best when air can circulate freely around them. A wooden holder lifts the packs off the bottom of your humidor, preventing moisture buildup underneath and ensuring even humidity distribution. The Spanish cedar construction also adds a subtle aroma that complements your cigars or cannabis.

Where to place the holder

For best results, mount the holder on a vertical wall inside your humidor, away from direct contact with cigars or cannabis. Avoid placing it near the humidor's seal or hygrometer, as air movement near those areas can cause inaccurate readings. The magnetic plate makes installation simple on any ferrous surface.

Step-by-step setup guide

Prepare the mounting surface: Wipe the inside wall of your humidor clean and dry. If the surface is not magnetic, attach the included metal plate using the adhesive backing (or a small screw if provided). A common mistake is mounting on a dusty or damp surface, which weakens the adhesive bond.
Attach the magnetic plate: Peel the backing from the magnetic plate and press it firmly onto the chosen spot. Hold for 30 seconds to ensure a strong bond. Wait 1 hour before adding the holder for best adhesion. Skipping the wait time can cause the plate to fall off when you insert the packs.
Mount the wooden holder: Align the metal bracket on the back of the wooden holder with the magnetic plate. It will snap into place securely. Gently tug to confirm it's locked. If the holder feels loose, check that the magnetic plate is fully seated and not tilted.
Insert Boveda packs: Slide two Boveda humidity control packs side by side into the slots of the wooden holder. Ensure they are fully seated and not overlapping. Using only one pack in a two-slot holder reduces humidity coverage; always use two for balanced output.
Check humidity after 24 hours: Close your humidor and let the system stabilize for 24 hours. Then check your hygrometer reading. Adjust the number of packs or holder position if needed. If the humidity is off by more than 2%, verify your hygrometer calibration before repositioning the holder.

Product details

Boveda Wooden Holder (Holds 2 Side by Side): Made of kiln dried Spanish cedar with a magnetic mounting plate for easy adherence. The Spanish cedar helps maintain stable humidity while the magnetic plate lets you reposition the holder without tools.
Boveda Wooden Holder (Holds 2 Side by Side)